Sod will either come rolled or in squares.
Your lawn will look better and last longer if you prepare the site well before you start sodding, clear away all weeds and debris, and firm and level the soil. Sodding is more expensive than sowing, but provided you look after the newly laid lawn, it will become usable more quickly - usually within two months. It is less likely than a seeded lawn to be damaged or uprooted early on. Still for all the advantages of sodding to pay off then a little preparation and planning is necessary. Does this Spark an idea?
Instructions
1. Choose a time to sod. Sod can be laid at almost any time of year, but try to avoid very dry or very wet spells and prolonged periods of high or low temperatures. Choose a time when the soil is moist, so that the grasses root well, but not too wet or the roots may rot off. An ideal time is when rain is forecast, since the newly-laid sod will then be watered in well without any effort on your part.
2. Prepare the yard for sodding. The aim when preparing for a new lawn is to create a completely clear, level surface. Avoid doing this too far ahead. Weeds may regrow and need to be treated again.
3. Remove all debris, weeds and the remains of any old grassy areas or lawn. Kill off or dig out perennial weeds when they are growing actively but before they have started to set seed. Digging is usually not enough to get rid of these weeds since if their taproots or rhizomes are broken, any small pieces left in the soil will form new plants. An easier solution is to spray the whole area with a systemic weed killer containing glyphosate, which is carried down to the plants' roots or rhizomes.
4. Firm the whole area by treading over it evenly. It may take several attempts to firm it well. Pay meticulous attention to the ends. Mark some pegs, each at the same distance from the top.
5. Drive in the pegs. For sowing, the marks should be at the required level of the lawn. For sodding, push the pegs ¾-inch (2cm) lower. If the lawn is next to paving, keep the marks level with the paving surface.
6. Add a parallel row of identically marked pegs, check they a re level with the first row and each other, and adjust them if necessary.
7. Rake the soil to the level of the marks on the pegs. When the silt, is level, remove the pegs. Firm the soil again, then add a granular lawn fertilizer and rake it in carefully, keeping the soil level.
8. Prepare the sod. Sad is delivered either rolled or stacked flat. If possible, avoid leaving it rolled up for more than a couple of days at a time, since it will quickly dry out and the grass will turn yellow, making the lawn hard to establish.
9. Starting at one side, lay the first row of sod along a straight edge. Roll out each piece so that it just touches the next. To lay the next row, kneel on a board to avoid damaging sod just laid. Stagger the joints to give an even finish.
10. When the whole area is laid, use the back of a rake or a light roller to firm down the sod and eliminate any air pockets. If necessary, brush in a sandy top-dressing to fill in any gaps. Keep the sod moist so that it roots quickly.
Tags: whole area, Choose time, lawn will, level with, moist that